MapAndValidateXML Failed


Author
Message
desii1
desii1
New Member
New Member (9 reputation)New Member (9 reputation)New Member (9 reputation)New Member (9 reputation)New Member (9 reputation)New Member (9 reputation)New Member (9 reputation)New Member (9 reputation)New Member (9 reputation)
Group: Forum Members
Posts: 8, Visits: 18
I'm getting MapAndValidateXML Failed popping up often.  Recently when I entered a new schedule.

I  just restored the disk the program is on.  A search for the error does not show up any previous entries. 

Suggestions?

Thanks
Al



jphughan
jphughan
Macrium Evangelist
Macrium Evangelist (7.2K reputation)Macrium Evangelist (7.2K reputation)Macrium Evangelist (7.2K reputation)Macrium Evangelist (7.2K reputation)Macrium Evangelist (7.2K reputation)Macrium Evangelist (7.2K reputation)Macrium Evangelist (7.2K reputation)Macrium Evangelist (7.2K reputation)Macrium Evangelist (7.2K reputation)
Group: Forum Members
Posts: 4.9K, Visits: 36K
When you did the restore, did that roll Reflect back to an older version?  If so, try updating it and seeing if that resolves the issue in case a newer version added an XML tag that the older version doesn't know about.  Otherwise, the XML file in question is your job definition file, so if your job definition isn't too complicated, it might be easiest to just manually create a new one from scratch, add your desired schedule entries to that one, and then delete the old file.  As long as you make the same selections, Reflect will continue to build on any existing backup sets.

Nick
Nick
Macrium Representative
Macrium Representative (3.1K reputation)Macrium Representative (3.1K reputation)Macrium Representative (3.1K reputation)Macrium Representative (3.1K reputation)Macrium Representative (3.1K reputation)Macrium Representative (3.1K reputation)Macrium Representative (3.1K reputation)Macrium Representative (3.1K reputation)Macrium Representative (3.1K reputation)
Group: Administrators
Posts: 1.8K, Visits: 10K
Hi Al

MapAndValidateXML error will occur if you initiate a Clone from a clone definition where the source of the clone cannot be found on the PC. This could be because partitions have changed size or if the source disk signatures have changed. 


Kind Regards

Nick - Macrium Support

Next Webinar


GO

Merge Selected

Merge into selected topic...



Merge into merge target...



Merge into a specific topic ID...




Reading This Topic

Login

Explore
Messages
Mentions
Search