I am trying to access my NAS on my network using the Rescue Media. The Network Config panel shows my network (wired) is connected. Under "Existing Backups" > "Edit" I clicked on the icon at the right end of the Add line, then clicked "Network" in the list, but nothing appears. When I manually enter the UNC for the NAS and appropriate folder, I get the "enter" credentials box. I enter them, then a "Connecting to" box starts but just hangs. If I cancel out, I end up with the message "The specific folder does not exist". Not sure where to go from here.

JohnD

+x

 

johnpd - 2 February 2023 6:04 AM

I am trying to access my NAS on my network using the Rescue Media. The Network Config panel shows my network (wired) is connected. Under "Existing Backups" > "Edit" I clicked on the icon at the right end of the Add line, then clicked "Network" in the list, but nothing appears. When I manually enter the UNC for the NAS and appropriate folder, I get the "enter" credentials box. I enter them, then a "Connecting to" box starts but just hangs. If I cancel out, I end up with the message "The specific folder does not exist". Not sure where to go from here.

JohnD

Any help with this?

JohnD

Can you successfully map a drive letter to the desired share by opening Command Prompt from the system tray and entering the appropriate "net use" command?

Thanks JP,
I was tied up with taxes and other things. I finally got around to trying the "net use" command. That worked fine.

Thanks again,
  JohnD